Issues with updating Braiins firmware on T17+

Hey everyone! I've got a T17+ miner that's currently missing its hashboards since they're being fixed. I tried to set up Braiins using an SD card. When I power it up, both lights blink together, on-off-on-off. After waiting an hour, they’re still doing that, so I ended up restarting it by myself. When I boot it up without the SD card, both lights light up at first with a steady glow. After a few minutes, they just go out completely and stay off. I can access it through the IP (it boots to the stock firmware), but when I check the miner status or the miner pool/worker name tabs, it’s just a blank page. Even the initial page showing the miner model, hardware, and software is empty. Has anyone dealt with something like this? I’m looking to get Braiins installed on the control board's "hard drive."

Hey You should wait the feedback from Artemis3 here : https://bitcointalk.org/index.php?topic=5412808.20;topicseen I saw you already post a message in the Braiinos topic, no one is more legit and qualified to answer than Artemis3 for Braiinos realted questions / issues

You maybe interrupt the flashing process which is why it ends up a corrupted program/soft bricked and maybe you are using a fake SD card with fake volume take note if you use a fake SD card to flash the unit sometimes it can bricked the control board so make sure that you are using original one and recommended size. If you are using the original one then repeat the procedure redownload the firmware and reformat the SD card then burn it again and flash the unit. Do this 3 times, if it still didn't work for 3rd try then replace the SD card or try other ways to flash the unit. Check the guide here https://docs.braiins.com/os/open-source-en/Setup/2_advanced.html#sd-card-image