swiftbit

Technically the minimum spec of the R909 is at least 1.5TH from at most 100W, but actual performance should be closer to 2TH at around 80 watts. Also, regarding editing the nonce range, that's not readily possible…

Closer now than I ever have been, what with both sample chips and dev funding. I'll be in BF16 prototyping as soon as I get 2Pac proof sticks out in a couple days. But yeah, it's actually been over 2 years. Novak and I…

Make sure it was the heatsink that fell off the chip, not the chip that fell off the board. Is the chip surface undamaged? There's a S17/T17 hack and repair thread here with a pretty decent writeup on how to re-solder…

If formfactors and power levels were standardized so swapping boards on waterblocks wasn't basically a customized rebuild with every successive generation - like how S3 waterblocks would fit on an S5 - it'd be a lot…

Heat desalination uses partial vacuums to reduce the boiling point. By decreasing the pressure in consecutive stages, you can heat water once to 80-90C and it'll boil off in one stage, then boil off again in the next,…

Could do desalination as well. A lot of desalination plants are set up next to industrial facilities to utilize waste heat.

A lot of miners were made with liquid cooling from the factory some years ago, especially when a lot of companies made large high-power CPU-type miners. And then they started realizing that exotic cooling solutions…

As an electronics builder in a family of beef and soybean farmers, I get to see the tariff double-whammy up close. China's retaliatory tariffs on us are for products they can buy from at least 20 other countries. But…